AT&T EL51209, EL51359 User Manual

Telephone base charger installation

Telephone base charger installation

Getting started
4
Telephone base & charger installation
Install the telephone as shown below.
The telephone base is ready for table use. If you want to change to wall 
mounting, see page 7 for details.
IMPORTANT INFORMATION
1. Use only the power adapter(s) supplied with this product. To order a replacement power 
adapter, visit our website at 
www.telephones.att.com
, or call 
1 (800) 
222-3111
. In Canada, dial 
1 (866) 288-4268
.
2. The power adapters are intended to be correctly oriented in a vertical or floor mount position. 
The prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-
the-table or cabinet outlet.
5. Plug the other end 
of the telephone 
line cord into a 
telephone jack or a 
DSL filter.
1. Plug one end of 
the telephone 
line cord into 
the telephone 
jack on the 
bottom of the 
telephone base.
3. Route the power 
adapter cord 
through the slot.
4. Plug the large end 
of the AC power 
adapter into a 
power outlet not 
connected to a wall 
switch.
2. Plug the small 
end of the AC 
power adapter 
into the power 
jack on the 
bottom of the 
telephone base.
Telephone line cord
If you have DSL high speed 
Internet service, a DSL filter 
(not included) is required.
Charger installation
Plug the AC power 
adapter into a power  
outlet not controlled 
by a wall switch.