"Selecting the Projection
Quality (Colour Mode
Other useful functions
The colour mode
changes as follows
each time this button
This function lets you display separate images in a smaller screen
(sub-screen) over the top of the images that are currently being
projected (main screen).
The images are paused and unpaused each time this button is
This lets you set the lamp brightness to one of two settings. Select
"Low" if the images being projected are too bright such as when
projecting images in a dark room or onto a small screen. When used
at low brightness, the life of the lamp will be extended.
"P in P (Picture in
and Control using a
The "Video" menu settings (such as input resolution and tracking) for the
respective preset number are retrieved each time this button is pressed.
(Adjustment is only possible when analogue RGB signals are being
This lets you monitor multiple projectors and turn their power on and
off and change the signal sources via a network.
In addition, if a problem occurs with the projector, the projector can
send an e-mail message to notify someone of the problem.
P in P
Adjusting the projection angle
Adjusting the image size and focus
While pulling the foot adjust lever,
lift up the front of the projector so
that the front adjustable foot can
extend. The Auto Keystone
function will operate when the
projector is tilted.
To retract the front adjustable foot,
gently push down on the projector
while pulling the foot adjust lever.
User's Guide "Zoom Function"
User's Guide "Height Correction"
Fitting the image size to the projection screen (Quick Corner)
The four corners of the image can be adjusted so that the image fits
the screen exactly. This cannot be used together with Auto Keystone.
1. Press the button.
Select "Quick Corner" from the "Keystone" sub-menu of the
2. Select the corner to be adjusted.
Press the button.
3. Adjust the corner to the desired position.
Tilt the button.
Once the adjustment is complete, press the button.
"Correcting Keystone Distortion so that the Projection Area Fits the Screen Exactly (Quick Corner)"
If tilted horizontally, adjust using the
left and right rear adjustable feet.
If the height of the image is too short after Auto
Keystone is carried out, adjust the height as follows.
For adjustment using the configuration menus:
"Setting" - "Keystone" - "H/V-Keystone" - "Height"
Fine adjustments to
Enlarge: Turn to "W"
Reduce: Turn to "T"
"Adjusting the Feets"
Foot adjust lever
[ ] :Move next
[ESC] :Return (Press 1 second