Yamaha RX-V2400 Owner Manual

Starting the setup

Starting the setup

25
English
AUTO SETUP
PRE
P
ARA
T
ION
For best results, make sure the room is as quiet as possible 
during the auto setup procedure. If there is too much 
ambient noise, the results may not be satisfactory.
y
If your subwoofer can adjust the output volume and the crossover 
frequency, set the volume to about half way (or slightly less) and 
set the crossover frequency to the maximum.
1
Switch on the receiver and video monitor.
Make sure the OSD is displayed.
2
Set PARAMETER/SET MENU to 
SET MENU.
3
Press 
k
/
n
 to select AUTO SETUP, 
then press + once to enter the main menu.
4
Press 
k
/
n
 repeatedly to select WIRING, 
DISTANCE, SIZE, EQUALIZING or LEVEL.
5
When WIRING, DISTANCE, SIZE or LEVEL is 
selected, press –/+ to select:
CHECK
To automatically check and adjust the selected 
item.
SKIP
To skip the selected item and perform no 
adjustments.
y
When using THX speakers, select SKIP and make sure that 
SMALL or SMLx2 is selected in SPEAKER SET (page 49) 
and that 80Hz is selected in CROSS OVER (page 50).
When EQUALIZING is selected, press –/+ to 
select:
FRONT
To adjust the frequency response of 
each speaker in accordance with the 
sound of your front speakers. 
Recommended if your front speakers 
are of much higher quality than your 
other speakers.
FLAT
To average the frequency response of 
all speakers. Recommended if all of 
your speakers are of similar quality.
LOW
To average the frequency response of 
all speakers, giving priority to the 
accuracy of bass frequencies.
MID
To average the frequency response of 
all speakers, giving priority to the 
accuracy of mid-range frequencies.
HIGH
To average the frequency response of 
all speakers, giving priority to the 
accuracy of high frequencies.
SKIP
To skip the selected item and perform 
no adjustments.
6
Press 
n
 to select SETUP, then press –/+ to 
select:
AUTO
To automatically perform the entire 
auto setup procedure.
STEP
To pause for confirmation between 
each check in the auto setup procedure.
RELOAD
To restore the last auto setup setting.
7
Press 
n
 to select START PUSH +, then press 
+.
Loud test tones will be output from each speaker and 
WAIT appears during the auto setup procedure.
If E-10:OTHER ERROR appears during testing, restart the 
procedure from step 3.
Starting the setup
PARAMETER
SET MENU
SET MENU
. ;AUTO SETUP
 ;MANUAL SETUP
: Up/Down
p
/p
: Select
- / +
1 AUTO:MENU
. WIRING;;;;;CHECK
DISTANCE;;;CHECK
SIZE;;;;;;;CHECK
EQUALIZING;;FLAT
LEVEL;;;;;;CHECK
SETUP;;;;;;;AUTO
START PUSH +
: Up/Down
p
/p
: Select
- / +
Note
00_RX-V2400U_EN.book  Page 25  Friday, October 10, 2003  10:54 AM