ZONE 2/ZONE 3 (U.S.A., CANADA AND AUSTRALIA MODELS ONLY)
Using this unit’s internal amplifier
To use this unit’s internal amplifier, select ON in ZONE2 AMP.
The supplied remote control can be used to control Zone
2/Zone 3. You can even select the input source and control
components located in the main room directly from the
second/third room regardless of the listening condition in
the main room.
To enable Zone mode on the remote
You will be able to switch the remote control mode from
one room to another, and use STANDBY, SYSTEM
POWER, MUTE and VOLUME +/– to control the
Set REC OUT/ZONE 2 on the front panel to
Repeat steps 1 and 2 of the procedure in
“Setting manufacturer codes” on page 60.
to select “L:AMP”.
to select “Zone”.
Press LEARN to complete the Zone setup.
The remote control will be able to operate this unit
from Zone 2 or Zone 3.
To control Zone 2/Zone 3
Press SOURCE SELECT
display “Zone2” or “Zone3” in the display
Press SYSTEM POWER to turn Zone 2 or
Zone 3 power on.
Press an input selector button to select the
input source you want to listen to in the
The display window shows “2: name of selected
input” if the remote control is in the Zone 2 mode.
Signals input to V-AUX and PHONO jacks cannot be sent to
Zone 2/Zone 3.
PRESENCE/ ZONE 2
Remote controlling Zone 2/Zone 3
REC OUT/ZONE 2
00_RX-V2400U_EN.book Page 73 Friday, October 10, 2003 10:54 AM